What and Why :
Two modes: Daily and Deep fractional
Combines three technologies in one: Red light, Radio frequency and EMS Microcurrent
*Featured with water-based conductive gel + Nourishing Ampoules x20 pack
Red light 620nm
- The red light stimulate collagen
- Reduce wrinkles
- Promote skin metabolism
- Provide activation energy for skin cell renewal
- Anti-aging
Radio frequency RF
- Makes skin molecules move at high speed generating heat energy
- Skin absorbs heat to synthesize collagen
- Reduces fine lines and wrinkles
- Restores elasticity
Microcurrent EMS
- Stimulates the brain to produce unconscious muscle movement
- Microcurrent prompts growth of collagen
- Enhances contour
How to use it :
Clean your face before using the device. Use it for 12min daily or deeply 1-2x/week for 30min. Do not watch the LED light source directly.
Features:
- Adopts body temperature control, avoiding becoming too hot
- Three times the number of electrodes = 3 times the lifting and firming action
- Flat guide head is seamless and very comfortable to use and to clean
- Overall dull tone, elasticity and roughness is improved
- Skin is brightened, lifted and tightened
1. How RF Works on Aging Skin: The Mechanism
Radiofrequency for skin rejuvenation uses high-frequency electromagnetic energy, typically 0.3 to 10 MHz: to generate controlled thermal energy within the dermal layer of the skin. Unlike light-based treatments that target chromophores such as melanin or hemoglobin, RF heats tissue based on its impedance to the electrical current, meaning it works across all skin tones.
The biological effect is twofold. First, when dermal tissue reaches approximately 40 to 42°C, existing collagen fibers contract immediately, producing the visible "tightening" that many users notice after a single session. This contraction is a thermal response of type I and type III collagen fibers, which denature and shorten at these temperatures.
Second, controlled thermal injury activates dermal fibroblasts to produce new collagen and elastin over the following weeks and months, a process called neocollagenesis and neoelastogenesis.
A proper RF and EMS facial treatment follows a clear four-step sequence: cleanse, apply conductive gel, glide the device in upward strokes, and finish with your regular skincare. Following these steps ensures the electrical currents travel safely into your skin while preventing irritation or heat spots.
1. Prep Your Skin
-
Remove all oil and makeup: Wash your face thoroughly with a gentle, oil-free cleanser. Any leftover sunscreen, moisturizer, or natural skin oils can block the current.
-
Pat completely dry: Gently pat your skin dry with a clean towel so the conductive gel adheres evenly.
-
Remove metal jewelry: Take off facial piercings, earrings, or necklaces near the treatment area to avoid electrical interference.
2. Apply Conductive Gel
-
Work in small sections: Apply a generous, even layer of water-based conductive gel to one area at a time, such as your right cheek and jawline. Applying gel to your whole face at once often causes it to dry out before you reach the other side.
-
Keep it wet: If the gel starts feeling sticky or dry during the session, mist your face with plain water or apply a little more gel.
3. Perform the Treatment
-
Start on the lowest setting: Turn on your device and begin at intensity level 1 to test your comfort, especially if you are new to EMS.
-
Maintain full contact: Press the metal treatment head flat against your skin so all probes touch the surface at the same time.
-
Glide upward and outward: Move the device slowly in steady, upward motions from the center of your face toward your hairline or ears.
-
Keep the head moving: Never hold an RF device still in one spot, as continuous motion prevents heat from building up and burning the skin.
-
Follow a logical path: Treat your jawline, cheeks, forehead, and neck (avoiding the center of your throat over the thyroid gland) for about 5 to 10 minutes total.
4. Post-Treatment Care
-
Rinse or wipe away gel: Wash off the remaining conductive gel with lukewarm water or wipe it away with a damp cloth.
-
Apply your regular skincare: Follow up immediately with your hydrating serums*, moisturizer, and facial oil to lock in moisture.
-
Stick to a safe schedule: Use the device 2 to 3 times per week, leaving at least one rest day between sessions so your facial muscles and skin barrier can recover.
Forbidden to use :
Pregnant women, baby and children, any sick person, heart conditions, epilepsy clients, thyroid problems, light allergic.